AWWA D100-11 PDF

AWWA Standard. The purpose of this standard is to provide minimum requirements for the. Al l tanks storing potable water shall have roofs. Items not covered.

Author:Mokasa JoJokora
Country:Timor Leste
Language:English (Spanish)
Genre:Science
Published (Last):11 September 2013
Pages:448
PDF File Size:11.55 Mb
ePub File Size:15.40 Mb
ISBN:142-1-56959-790-5
Downloads:1908
Price:Free* [*Free Regsitration Required]
Uploader:Vojin



The purpose of this standard is to provide guidance to facilitate the design, manufacture, and procurement of welded carbon steel tanks for the storage of water.

This standard does not cover all details of design and construction because of the large variety of sizes and shapes of tanks. Where details for any specific design are not given, it is intended that the constructor, subject to the approval of the purchaser, shall provide details that are designed and constructed to be adequate and as safe as those that would otherwise be provided under this standard.

Details that are not addressed shall be designed and constructed to be adequate and as safe as those that would otherwise be provided under this standard.

And this standard does not cover concrete—steel composite tank construction. Claudia's Notes: This edition of the standard includes numerous corrections, updates, and new material to clarify some of the existing requirements. Section 1 was revised to show the latest edition of references. Section 3 was revised to match the wind exposure definitions of ASCE Section 10 was revised to include an erection tolerance multiplier for elements of ground-supported flat-bottom tanks that are designed in accordance with Sec.

Section 11 was revised to make leak testing of the bottom-to-shell joint mandatory for all ground-supported flat-bottom tanks. Section 13 was revised to not require a site response analysis for short-period structure located on liquefiable soils. The scaling requirement for the alternate procedures was clarified. Section 14 was revised to clarify the DMT-thickness requirement for Category 1 and Category 2 materials when impacts are provided.

Phone: Fax: Email: info document-center. Prices subject to change without notice.

BLUMEA LACERA PDF

ANSI/AWWA D100-11

The purpose of this standard is to provide guidance to facilitate the design, manufacture, and procurement of welded carbon steel tanks for the storage of water. This standard does not cover all details of design and construction because of the large variety of sizes and shapes of tanks. Where details for any specific design are not given, it is intended that the constructor, subject to the approval of the purchaser, shall provide details that are designed and constructed to be adequate and as safe as those that would otherwise be provided under this standard. Details that are not addressed shall be designed and constructed to be adequate and as safe as those that would otherwise be provided under this standard.

DIGITAL ELECTRONICS AND LOGIC DESIGN BY B.SOMANATHAN NAIR PDF

AWWA D100-11 Welded Carbon Steel Tanks for Water Storage

This standard covers coating systems for coating and recoating the inside and outside surfaces of steel tanks used for potable water storage in water supply service. Your Alert Profile lists the documents that will be monitored. If the document is revised or amended, you will be notified by email. You may delete a document from your Alert Profile at any time. This standard is also available to be included in Standards Subscriptions.

MAKROKOSMOS GEORGE CRUMB PDF

Previews AWWA D100 11 Pre

.

HP XW8200 MANUAL PDF

.

Related Articles